Polyester Adhesive Fluid - Vertical Solid

DUAL-COMPONENT ADHESIVE FOR GLUING MARBLE, NATURAL AND ARTIFICIAL STONE Polyester resin adhesives feature high-reactivity rapid hardening, no shrinkage from substrate materials during reticulation and low shrinkage upon hardening (1 to 6%). This adhesive product is the culmination of GENERAL® Chemical Engineering’s extensive knowledge and experience in the use of polyester resins on marble and natural stone. POLYESTERE is one of the highest quality products available on the market today because we choose only very high quality primary materials and select only suppliers who conform to strict criteria. This quality control process assures consistency in the product’s physical and mechanical properties. The mineral fillers used in POLYESTERE adhesives are carefully monitored to ensure purity, inertia and proper granular dimensions which together form a durable and consistent product. Continuous research and innovation enable GENERAL® Chemical Engineering to respond to the needs of the market with a wide range of products. 

POLYESTERE is available in: 

POLYESTERE FLUID (PF) 

POLYESTERE VERTICAL/SOLID (PV)

TECHNICAL DATA 

PHYSICAL STATE 

paste (PV) fluid (PF) 

COLOUR straw, white, black, grey, red 

DENSITY at 25°C (77°F) 1,65 g/cm³ (PV) 1,4 g/cm³ (PF) 

CHEMICAL STABILITY 6 months stored in dry place, at room temperature of 15-25°C (59-77°F) in tightly closed original containers.

PREPARATION 

For best results, mix 2 to 3% of the catalyst (dibenzoyl peroxide) with the adhesive concentrate. This paste formula is easier to measure accurately. A consistent mixture will facilitate uniform catalysis. The catalysis rate is affected by temperature and by the proportion of catalyst. An excess of hardener will increase the catalysis rate, but weakens the adhesive’s seal. Surfaces to be treated must be clean and dry; porosity and unevenness of the surface favour the best adhesion. NOTE: Straw coloured adhesive can be used with BASE COLORE (special colouring pastes) for colour variation. Never colour white adhesive. Colouring weakens adhesive performance. Hardened adhesive is completely workable (sanding, buffing, etc.) after 2 to 5 hours. SPECIFICATIONS